TASK: This Porsche 911 C4S had some minor dents and scuffs to the lower wheelarch. The dents were filled and sanded to shape and vehicle masked ready for the application of a 2 component primer. This primer was cured and then sanded flat ready for the professional application of the pearlescent base coat and 2…
TASK: This Toyota had suffered a quite severe impact to the front bumper causing a dent and splitting the plastic. Once we had removed the dent and reshaped the bumper, the split was plastic welded back together to produce a durable repair Various stages were then carried out to prepare the bumper surface for base…
TASK: This Mercedes E Class required the dented and scuffed front bumper to be repaired. The first stage was to heat the bumper to a specific temperature in order to be able to restore the shape without stretching the plastic. Once the shape was correct, a fine layer of special flexible bumper filler was applied…
TASK: This Audi R8 had suffered from light scuffs on the rear bumper and rear quarter panel. The damaged area was repaired, panels prepped and vehicle was masked up to keep the vehicle free of any dust and over spray. A 2 component primer was applied and then dried using infra red. This new primer…
TASK: Our client came to us with a couple of small but noticeable dents on the front wing of their VW Tiguan. The dents were removed with the use of welded on studs and then various stages were carried out to return the panel to original condition. The final top coats of lacquer were cured…
TASK: This Range Rover had a small dent and scuff through the paint on the rear quarter panel and also some scuffing on the adjacent bumper. The area was cleaned and degreased ready for work to commence. The dented area was prepared for a fine layer of filler. once the dent had been repaired the…
TASK: This Porsche Cayenne had a creased dent to the rear quarter and adjacent rear door. Special pins were welded to the metal enabling the dent to be removed as much as possible. The dents were then leveled off with a fine layer of filler to provide a flat surface for the following 2 component…
TASK: This Citroen had a large dent on the drivers side front wing. The first steps were to remove the wheel arch trim so access to the rear of the dent could be gained. The dent was then pushed out using various techniques, Ready for a fine layer of filler to completely level the dent.…
TASK: This Chrysler 300C had suffered a dented wing and the front bumper had been scuffed and un clipped. Pins were welded on to pull the line of the wheel arch back into shape and the dent was removed as much as possible. A fine layer of filler was then applied and sanded flat to…
